Add/Edit A Mac Based Vlan; Vendor Id Based Vlan - ZyXEL Communications XMG1930-30 User Manual

Table 211 SWITCHING > VLAN > MAC Based VLAN Setup (continued)
LABEL
Priority
Add/Edit
Delete

56.12.1 Add/Edit a MAC Based VLAN

Click Add/Edit, or select an entry and click Add/Edit in the SWITCHING > VLAN > MAC Based VLAN Setup
screen to see this screen.
Figure 284 SWITCHING > VLAN > MAC Based VLAN Setup > Add/Edit
The following table describes the fields in the above screen.
Table 212 SWITCHING > VLAN > MAC Based VLAN Setup > Add/Edit
LABEL
Name
MAC Address
VID
Priority
Apply
Clear
Cancel

56.13 Vendor ID Based VLAN

The Vendor ID based VLAN feature assigns incoming untagged packets to a VLAN and classifies the
traffic based on the source MAC address of the packet. When untagged packets arrive at the switch,
the source MAC address of the packet is looked up in a Vendor ID to VLAN mapping table. If an entry is
found, the corresponding VLAN ID is assigned to the packet. The assigned VLAN ID is verified against the
Chapter 56 VLAN
DESCRIPTION
This field displays the priority level which is assigned to frames belonging to this MAC-based
VLAN entity.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entry.
DESCRIPTION
Enter a name up to 32 alphanumeric characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ] for the
MAC-based VLAN entry.
Enter a MAC address that is bind to the MAC-based VLAN entry. This is the source MAC
address of the data packet that is looked up when untagged packets arrive at the Switch.
Enter an ID (from 1 to 4094) for the VLAN that is associated with the MAC-based VLAN entry.
Enter a priority (0 to 7) that the Switch assigns to frames belonging to this VLAN. The higher
the numeric value you assign, the higher the priority for this MAC-based VLAN entry.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XMG1930 Series User's Guide
399