Table of Contents
Advertisement
Table 110 Advanced Application > Multicast > MVR (continued)
LABEL
*
Source Port
Receiver Port
None
Tagging
Add
Cancel
VLAN
Active
Name
Mode
Source Port
Receiver Port
802.1p
Delete
Cancel
23.6.1 MVR Group Configuration
All source ports and receiver ports belonging to a multicast group can receive multicast data sent to
this multicast group.
Use this screen to configure MVR IP multicast group address(es). Click the Group Configuration
link in the MVR screen.
Note: A port can belong to more than one multicast VLAN. However, IP multicast group
addresses in different multicast VLANs cannot overlap.
Chapter 23 Multicast
DESCRIPTION
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this option to set this port as the MVR source port that sends and receives multicast
traffic. All source ports must belong to a single multicast VLAN.
Select this option to set this port as a receiver port that only receives multicast traffic.
Select this option to set the port not to participate in MVR. No MVR multicast traffic is sent
or received on this port.
Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the multicast VLAN ID. Click on an index number to change the settings.
This field displays whether the multicast group is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port number(s).
This field displays the receiver port number(s).
This field displays the priority level.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
To delete a multicast VLAN(s), select the rule(s) that you want to remove, then click the
Delete button.
Click Cancel to clear the check boxes.
GS3700/XGS3700 Series User's Guide
248
Advertisement
Table of Contents
