Mvr Group Configuration; Figure 20-7 Mvr Group Configuration - ZyXEL Communications GS-3012 User Manual

LABEL
None Select this option to set the port not to participate in MVR. No MVR multicast traffic is sent or received
on this port.
Tagging Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames transmitted.
Add Click Add to save the settings.
Cancel Click Cancel to discard all changes.
VLAN This field displays the multicast VLAN ID.
Active This field displays whether the multicast group is enabled or not.
Name This field displays the descriptive name for this setting.
Mode This field displays the MVR mode.
Source Port This field displays the source port number(s).
Receiver Port This field displays the receiver port number(s).
Delete To delete a multicast VLAN(s), select the rule(s) that you want to remove in the Delete column, then
click the Delete button.
Cancel Click Cancel to clear the Delete check boxes.

20.7 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive multicast data sent to this multicast
group.
Configure MVR IP multicast group address(es) in the Group Configuration screen. Click Group Configuration
in the MVR screen.
A port can belong to more than one multicast VLAN. However, IP multicast group addresses in
Multicast
Table 20-4 MVR
different multicast VLANs cannot overlap.

Figure 20-7 MVR Group Configuration

GS-3012/GS-3012F User's Guide
DESCRIPTION
20-9