Devicenet Network Control - Delta AS Series Manual

AS Ser ies M od ul e Man ua l
Configure the DeviceNet network by following the steps above. The IO data mappings between

AS01DNET-A and the slave are shown in the following tables.
AS01DNET-A → Slave

11
Slave → AS01DNET-A

Saving configuration data

Select File>> Save to save current network configuration.
11.4.7.3.

DeviceNet Network Control

This section describes how to write a ladder program to achieve the control requirement of the DeviceNet network.
PLC Programs

The program in the PLC connecting AS01DNET slave:

Program Explanation:
The contents in D26000~D26003 are the data received from the master and the contents in D26100~D26103
are the data transmitted to the master. SM400 is a normally open contact. The program above can make the
contents in D26000~D26003 move to D26100~D26103.
The program in the PLC connecting AS01DNET master:

11 - 2 8
AS PLC AS01DNET(Master)
D26105
D26106
D26107
D26108
AS PLC AS01DNET(Master)
D26005
D26006
D26007
D26008
AS01DNET(Slave)
AS01DNET(Slave)
AS PLC
D26000
D26001
D26002
D26003
AS PLC
D26100
D26101
D26102
D26103