Delta AS Series Manual page 364

Hide thumbs Also See for AS Series:

Table of Contents

AS Ser ies M od ul e Man ua l

.6.5 Remote IO Application (Multiple AS-FEN02)

When AS-FEN02 is installed on AS Series PLC, it can be used as the Ethernet port of the CPU.

The following example shows how to add multiple AS00SCM-A (RTU) + AS-FEN02 (hereafter referred to as the

"RTU") to an AS Series PLC in EIP connection. All IP addresses of RTU are set by the software.

AS00SCM-A + AS-FEN02

Step 1 Set up an IP address for the RTU

Turn all the knobs of the FORMAT 2 of the 3 new RTUs to 0. The default IP addresses are 192.168.1.3. Refer to

section 9.4.2.2 for more information on using IP Setting Tool to set up the IP address.

After the IP addresses of the 3 new RTUs are set, you can scan and add them in the network and connect to the AS

Series PLC. Do not download the project before uploading the already set RTU values to the network.

Now you can set up the right-side module of RTU. Refer to section 9.6.4 for more details. Scan all the RTU and save

the parameters. Make sure the data mapping table is updated and then download the project, including the

parameters, configurations, and data mapping table to the AS Series PLC and the RTUs.

master/scanner

EtherNet/IP slave/adapter

Digital output

Digital input

192.168.1.30

192.168.1.31

192.168.1.32

The right side of RTU

Data Mapping Area

D29540~D29559

D29180~D29199

D29360~D29379

Show Quick Links

Chapters

Table of Contents