Delta AS Series Manual page 310

Hide thumbs Also See for AS Series:

Table of Contents

AS Ser ies M od ul e Man ua l

Steps for a quick setup

1. Set up the PLC:

1000kbps; download the parameters.

2. Set up AS00SCM-A; set the ID1 knob to 0 and FORMAT1 to 8; ID2 knob to 9 and FORMAT2 to 7.

3. Supply power to AS00SCM-A and connect AS00SCM-A to the PLC with a CANopen cable.

4. Resupply power to the PLC and the indicator of CARD2 should keep blinking. That indicates

AS00SCM-A and the PLC are connected. The PLC error indicator should be blinking too, since the

setting is not done yet.

5. Use HWCONFIG to scan the connected devices to see if AS00SCM-A is connected.

6. Download the parameters and check if the PLC error indicator has stopped blinking. Then the setting

of one RTU device is complete.

Delta Special Driver & AS Remote Mode

m mode, number of the device: 1; baud rate:

Show Quick Links

Chapters

Table of Contents