Viewing Mlt Lacp Configuration Information For Aggregators - Avaya 8600 Configuration Manual

MLT and SMLT link aggregation configuration using the CLI
Prerequisite
• Before removing a port member from an MLT, you need to first disable the port. This ensures
that the other side will bring its corresponding port member down. This achieves parity on
both sides and avoids traffic disruptions.
Procedure steps
1. Remove ports from an MLT LAG by using the following command:
config mlt <mid> remove
Variable definitions
Use the data in the following table to help you use the config mlt <mid> remove
command.
info
<ports>
ports
<vid>
vlan
Viewing MLT LACP configuration information for
aggregators
View the MLT LACP configuration information per aggregator to obtain LACP configuration
information per aggregator.
98 Configuration — Link Aggregation, MLT, and SMLT
Variable
Comments? infodev@avaya.com
Value
Shows the ports and VLANs removed from the
MLT.
Removes ports from the MLT.
• ports is the port number or a list of ports you
want to remove from the MLT.
Removes a VLAN from the MLT.
• vid is the VLAN ID or a list of VLAN IDs you
want to remove from the LAG. The range is
1–4094.
January 2012