Mlt And Smlt Show Commands - Avaya 8600 Configuration Manual

Prerequisites
• You must log on to the Global Configuration mode in the ACLI.
View the MLT port calculated by the MLT hash algorithm to view the MLT port calculated by
the distribution algorithm for R, RS, and 8800 modules.
Procedure steps
1. View the MLT port calculated by the MLT hash algorithm by using the following
command:
sys hash-calc getmltindex traffic-type <ipv4|ipv6|non-ip> dest-
val <WORD 1-1536> src-val <WORD 1-1536> mltID <1-256> [dest-
port <0-65535>] [src-port <0-65535>]
The source and destination addresses cannot have the same value.
Variable definitions
Use the data in the following table to help you use the sys hash-calc command.
dest-val
src-val
mltID <value>
traffic-type

MLT and SMLT show commands

This section describes the MLT and SMLT show commands. Use the commands to display
information and statistics about MLT operation in the switch commands.
Configuration — Link Aggregation, MLT, and SMLT
Variable
<value>
<value>
{ipv4|ipv6|non-ip}
MLT and SMLT show commands
Value
Specifies the destination address in the
range form 1–1536. The source and
destination addresses cannot have the same
value.
Specifies the source address in the range
from 1–1536. The source and destination
addresses cannot have the same value.
Specifies the MLT ID. The value ranges from
1–256.
The type of traffic. Specify one of ipv4, ipv6,
or non-ip.
January 2012 141