MLT and SMLT link aggregation configuration using the CLI
create ip
delete
disable
enable
info
<mid>
Creating an interswitch trunk from an existing MLT
Create an interswitch trunk from an existing MLT to create an IP VLAN id.
Procedure steps
1. Create an interswitch trunk from an existing MLT by using the following command:
config mlt <mlt-id> ist create ip <value> vlan-id <value>
Variable definitions
Use the data in the following table to help you use the config mlt <mlt-id> ist create
ip <value> vlan-id <value> command.
<value>
ip
<mlt-id>
vlan-id
102
Configuration — Link Aggregation, MLT, and SMLT
Variable
<value>
vlan-id
<value>
Variable
<value>
Comments? infodev@avaya.com
Value
Creates an interswitch trunk from an existing
MLT.
•
value is a peer IP address
ip
•
<value> is an integer value.
vlan-id
The peer IP address is the IP address of the
IST VLAN on the other aggregation switch.
Deletes an existing IST.
You must disable an IST before you can
delete it.
Disables an existing IST.
Enables an existing IST.
Shows current level parameter settings and
next level directories.
Specifies the MLT ID.
Value
Specifies the IP address of the peer switch
Specifies the MLT ID.
Specifies the VLAN ID.
January 2012