Procedure steps
1. View MLT LACP configuration information per aggregator by using the following
command:
show mlt lacp info <ifindex>
Configuring LACP on an MLT
Configure an MLT with LACP to use the dynamic link aggregation function.
Prerequisites
• To attach ports to an aggregator, their system priorities must be the same; otherwise, they
are considered to be operating in two different switches.
• To attach ports to an aggregator, the actor admin key must match the key of the LAG.
Procedure steps
1. Configure LACP on an MLT by using the following command:
config mlt <mlt id> lacp
Variable definitions
Use the data in the following table to help you use the config mlt <mlt id> lacp
command.
clear-link-aggregate
disable
enable
Configuration — Link Aggregation, MLT, and SMLT
Variables
Value
Clears link aggregation for a specific MLT.
Using clear-link-aggrgate is equivalent to
disabling and re-enabling LACP on the
multilink trunk.
Disables LACP for a specific MLT. When
disabled, the multilink trunk functions as a
legacy multilink trunk.
Enables LACP for a specific MLT.
Configuring LACP on an MLT
January 2012
99