config mlt <mid> smlt
Variable definitions
Use the data in the following table to help you use the config mlt <mid> smlt
command.
create smlt-id
delete
info
<mid>
Creating an interswitch trunk
Create an interswitch trunk from an existing MLT.
Procedure steps
1. Create an interswitch trunk to create an interswitch trunk by using the following
command:
config mlt <mid> ist
Variable definitions
Use the data in the following table to help you use the config mlt <mid> ist
command.
Configuration — Link Aggregation, MLT, and SMLT
Variable
<value>
Value
Creates a split MultiLink trunk from an
existing MultiLink trunk.
• value is an integer value with a range of 1
to 256. The value must match the peer
switch SMLT-ID.
If the split MultiLink trunk, ID already exists
on a single port split MultiLink trunk, you
cannot assign it to an MLT-based split
MultiLink trunk.
Deletes an existing SMLT.
Shows ports and VLANs added to the
MultiLink trunk.
Specifies the MLT ID.
Creating an interswitch trunk
January 2012
101