MLT and SMLT link aggregation configuration using the CLI
MLT and SMLT show commands
Use the MLT and SMLT show commands to display information and statistics about MLT
operation in the switch.
Note:
If you disable and enable the SMLT or IST ports, the designated port information may not
appear correctly.
MLT and SMLT show commands navigation
•
Viewing MLT information
•
Viewing information about collision errors
•
Viewing information about Ethernet errors
•
Viewing MLT status
•
Viewing interswitch trunk status
•
Viewing SMLT status
•
Viewing all ports configured for single port SMLT
•
Viewing a port configured for Single Port SMLT
Viewing MLT information
View all MLT information to verify all MLT information.
Procedure steps
1. View all MLT information by using the following command:
show mlt show-all [file <value>]
Variable definitions
Use the data in the following table to help you use the show mlt show-all [file
<value>] command.
108
Configuration — Link Aggregation, MLT, and SMLT
on page 108
on page 110
on page 110
on page 111
Comments? infodev@avaya.com
on page 109
on page 109
on page 111
on page 111
January 2012