Viewing Vlacp Flap Detect And Damping Configuration - Avaya 8600 Configuration Manual

VLACP configuration using the ACLI
Variable definitions
The following table defines optional parameters that you enter to configure VLACP flap detect
and damping.
enable
<frequency>
<interval>

Viewing VLACP flap detect and damping configuration

View the VLACP configuration to view the current flap detect and damping settings.
Procedure steps
1. To view VLACP configuration and VLACP Flap information, use the following
2. To clear VLACP information, use the following command:
150 Configuration — Link Aggregation, MLT, and SMLT
vlacp flap-interval <interval>
Variable
command:
show vlacp
clear vlacp flap-stats port
Comments? infodev@avaya.com
Value
Turns on VLACP flap detect and damping.
The feature is disabled by default.
To disable the feature, use the
with the command
Specifies the number of flaps, per interval.
The value ranges from 3-30.
The default value is 3.
To set the default value, use the
operator with the command
Specifies the flap interval, in seconds. The
value ranges from 10-600.
The default value is 60.
To set the default value, use the
operator with the command
no operator
default
default
January 2012