MLT and SMLT link aggregation configuration using the ACLI
show smlt mlt
MLT Interface Configuration mode
ist peer-ip default ist
peer-ip
ist peer-ip <A.B.C.D> vlan
<vlan-id>
smlt <port ID>
smlt <smlt ID>
Configuring an MLT
Configure an MLT to set up MLTs on the switch.
Prerequisites
• You must log on to the Global Configuration mode in the ACLI.
Procedure steps
1. Configure an MLT by using the following command:
mlt <mlt ID>
Variable definitions
Use the data in the following table to help you use the mlt <mlt ID> command.
enable
encapsulation dot1q
member <portList>
<mlt ID>
name <0-20>
132
Configuration — Link Aggregation, MLT, and SMLT
Command
Variable
Comments? infodev@avaya.com
Parameter
Value
Creates and enables a new MLT.
Sets encapsulation.
dot1q
on the MLT.
Adds ports to this MLT.
Specifies the MLT ID in the range of 1–256.
Changes the name for this MLT in the range
of 0–20 characters.
enables trunking
January 2012