Avaya 8600 Configuration Manual page 69

Variable
VlanIds
MltType
RunningType
SmltId
AggMinLink
IfIndex
Multicast Distribution
ClearLinkAggregate
NtStgEnable
DesignatedPort
Aggregatable
Configuration — Link Aggregation, MLT, and SMLT
Important:
Ensure that all ports that belong to the same MLT/LACP
group use the same port speed, for example, 1 Gbit/s, even
if auto-negotiation is enabled.
Indicates to which ports the VLANs belong.
When the aggregation field is set to enable, this field is read-
only.
Specifies the type of MLT:
• normalMLT (default)
• istMLT
• splitMLT
SMLT running type.
The default value is normalMLT.
The SMLT ID assigned to both ends of the split trunk.
The corresponding SMLT between aggregation switches must
have the same SMLT ID.
Configures the minimum number of active links (MinLink)
required for the LAG to remain in forwarding state. If the
number of active links falls below this number, the Ethernet
Routing Switch 8800/8600 declares the entire LAG down. The
default is 1, and the range is 1 to 8.
Interface index.
The multicast distribution feature state on MLT ports:
• enable
• disable (default)
You must also configure Multicast distribution on the chassis
(Edit, Chassis, Mcast MLT Distribution). For more information,
see Avaya Ethernet Routing Switch 8800/8600 Configuration
— IP Multicast Routing Protocols, NN46205-501 .
Disables and re-enables aggregation on the MLT.
Specifies if this MLT is operating in Avaya Mode or in Cisco
Mode.
• true—Avaya mode (default)
• false—Cisco mode
Indicates the designated port the switch uses to send multicast
traffic to the MLT, if the multicast distribution feature is
disabled.
Specifies whether link aggregation is enabled or disabled.
Adding a MultiLink/LACP trunk
Value
January 2012 69