Procedure steps
1. At the system prompt, enter the following command
config mlt <ID> ist spanning-tree enable
Disabling SMLT Interoperability with MSTP using CLI
Use the following procedure to disable SMLT Interoperability for MSTP.
Procedure steps
1. At the system prompt, enter the following command
config mlt <ID> ist spanning-tree disable
Note:
If you want to disable SMLT Interoperability for MSTP, ensure that you remove redundant
paths, for VLANs, to the existing IST path. To prevent the formation of a bridging loop and
network failure, do not break or remove an MSTP device chain until you disable SMLT
interoperability.
Displaying MLT IST information using CLI
Use the following procedure to display IST MLT information for your switch.
Procedure steps
1. At the prompt, enter the following command
Configuration — Link Aggregation, MLT, and SMLT
Disabling SMLT Interoperability with MSTP using CLI
January 2012
105