Configuring Lacp On A Port - Avaya 8600 Configuration Manual

Configuring LACP on a port

Configure LACP on a port to enable or disable LACP on the selected ports.
A port can operate in active or passive mode. You can configure a port to be an individual link
or an aggregated link.
Important:
Changes made at the global level override and reset all port level settings.
Prerequisites
• You must log on to the Interface Configuration mode in the ACLI.
Procedure steps
1. Configure LACP on a port by using the following command:
lacp enable
Variable definitions
The following table defines optional parameters that you enter after the lacp enable
command.
aggregation enable
aggr-wait-time <200–2000>
fast-periodic-time <200–20000>
key <0–65535>
Configuration — Link Aggregation, MLT, and SMLT
Variable
Sets the port as aggregatable. Use the
remove this configuration. To set this option to the
default value, use the
command.
The default value is disable.
Sets the aggregation wait time (in milliseconds) for this
port.
The default value is 2000 ms.
Sets the fast-periodic time (in milliseconds) for this port.
The default is 1000 ms.
Sets the aggregation key for this port.
Configuring LACP on a port
Value
operator to
no
default operator with the
January 2012 127