MLT and SMLT link aggregation configuration using the ACLI
<smltid>
Creating an interswitch trunk
Create an interswitch trunk from an existing MLT.
Prerequisites
• You must log on to the Global configuration mode in the ACLI.
Procedure steps
1. To log on to the Interface MLT Configuration mode for the MLT that you want to
2. Create an interswitch trunk by using the following command:
Variable definitions
Use the data in the following table to help you use the ist peer-ip command.
<A.B.C.D>
<1–4094>
136
Configuration — Link Aggregation, MLT, and SMLT
Variable
configure enter the following at the Global configuration command prompt:
interface mlt <mltid>
Tip:
Specify an MLT ID in the range 1-256 for <mltid>.
ist peer-ip <A.B.C.D> vlan <vid>
Variable
Specify the peer IP address—the IP address of the IST
VLAN on the other aggregation switch.
Specify the VLAN ID.
Comments? infodev@avaya.com
Value
Specifies the Split MLT ID in the range of 1–
256. The value must match the peer switch
SMLT ID.
Value
January 2012