Configuring A Single Port Smlt - Avaya 8600 Configuration Manual

MLT and SMLT link aggregation configuration using the ACLI
Procedure steps
1. Delete an interswitch trunk by using the following command:
no ist peer-ip
Job aid: Example of deleting an interswitch trunk
The following example shows the commands that you use to delete an interswitch trunk.
Procedure steps
1. From Global configuration mode, log into the MLT interface:
2. Disable the IST:
3. Delete the IST:

Configuring a single port SMLT

Configure a split MultiLink trunk that uses a single port. Use single port SMLT to permit the
scaling of the number of SMLT on a switch to the maximum number of available ports.
Important:
You cannot use SMLT on router ports. Only VLACP is supported on single port SMLT.
Prerequisites
• If the port is configured as MLT or MLT-based SMLT, you cannot configure a single port
SMLT.
• You must log on to the Gigabit Interface Configuration mode in the ACLI.
138 Configuration — Link Aggregation, MLT, and SMLT
ERS-8600:6(config)# interface mlt 2
ERS-8600:6(config)# no ist enable
ERS-8600:6(config)# no ist peer-ip
Comments? infodev@avaya.com
January 2012