Chapter 13: VLACP configuration using the
Configure Virtual LACP (VLACP) to implement link status control protocol at the port level. VLACP detects
for end-to-end failures in the Avaya Ethernet Routing Switch 8800/8600. Note that VLACP cannot
interoperate with LACP.
Job aid: Roadmap of VLACP commands
The following table lists the commands and their parameters that you use to complete the
procedures in this section.
Privileged EXEC mode
show vlacp interface
Global Configuration mode
vlacp enable
no vlacp enable
Interface Configuration mode
vlacp
Configuration — Link Aggregation, MLT, and SMLT
ACLI
Command
Parameter
<cr>
fastethernet [vid {vlan-id[-
vlan-id][,...]}] [<portList>]
gigabitethernet [vid {vlan-
id[-vlan-id][,...]}]
[<portList>]
enable
ethertype <1-65535>
fast-periodic-time <10-20000>
funcmac-addr
<0x00:0x00:0x00:0x00:0x00:0x0
0>
January 2012
145