Deleting An Interswitch Trunk; Enabling Smlt Interoperability With Mstp Using Cli - Avaya 8600 Configuration Manual

MLT and SMLT link aggregation configuration using the CLI

Deleting an interswitch trunk

Delete an interswitch trunk.
Prerequisites
• Before you can delete the interswitch trunk, you must disable the interswitch trunk. For more
information, see
Procedure steps
1. Delete an interswitch trunk by using the following command:
config mlt <mlt-id> ist delete
Variable definitions
Use the data in the following table to help you use the config mlt <mlt-id> ist
<enable|disable> command.
<mlt-id>

Enabling SMLT Interoperability with MSTP using CLI

Use the following procedure to enable SMLT Interoperability for MSTP.
Prerequisites
• Configure your switch to MSTP mode.
• Configure an IST MLT.
104 Configuration — Link Aggregation, MLT, and SMLT
Enabling and disabling an interswitch trunk
Variable
Specifies the MLT ID.
Comments? infodev@avaya.com
on page 103.
Value
January 2012