Configuring Lacp On An Mlt - Avaya 8600 Configuration Manual

MLT and SMLT link aggregation configuration using the ACLI
no mlt <mlt-id> member <portlist>

Configuring LACP on an MLT

Configure an MLT with LACP to use the dynamic link aggregation function.
Important:
Attach ports to an aggregator only if their system priorities are the same; otherwise, they
are considered to be operating in two different switches. You can attach ports to an
aggregator only if their keys are the same.
Prerequisites
• You must log on to the Global configuration mode in the ACLI.
Procedure steps
1. To log on to the Interface MLT Configuration mode for the MLT that you want
2. Configure LACP on an MLT by using the following command:
Variable definitions
Use the data in the following table to help you use the lacp enable key <integer>
command.
key <integer>
134 Configuration — Link Aggregation, MLT, and SMLT
configure LACP on enter the following at the ACLI Global configuration command
prompt:
interface mlt <mltid>
Tip:
Specify an MLT ID in the range 1-256 for <mltid>.
lacp enable key <integer>
Variables
Comments? infodev@avaya.com
Value
Sets LACP aggregator key for a specific
MLT.
• integer is the LACP actor admin key.
The default value is 0.
January 2012