Configuring Lacp On A Port - Avaya 8600 Configuration Manual

Link aggregation configuration using the CLI
config lacp
Variable definitions
Use the data in the following table to help you use the config lacp command.
aggr-wait-time <milliseconds>
disable
enable
fast-periodic-time <milliseconds>
info
smlt-sys-id <baseMAC>
system-priority <integer>
slow-periodic-time<milliseconds>
timeout-scale <integer>

Configuring LACP on a port

Configure LACP on a port to enable or disable LACP on the selected ports.
A port can operate in active or passive mode. You can configure a port to be an individual link
or an aggregatable link.
88 Configuration — Link Aggregation, MLT, and SMLT
Variable
Comments? infodev@avaya.com
Value
Sets the aggregation wait time (in milliseconds) for
a specific port type.
The default value is 2000.
Disables LACP for a specific port type.
Enables LACP for a specific port type.
The default value is disable.
Sets the fast-periodic time (in milliseconds) for a
specific port type.
The default value is 1000.
Shows the current level parameter settings and
next level directories.
Sets the LACP system ID globally. Enter a MAC
address in the following format:
0x00:0x00:0x00:0x00:0x00:0x00.
Sets system priority for a specific port-type.
• integer is the system priority value. The integer
value ranges from 0 to 65535.
The default value is 32768.
Sets the slow periodic time globally.milliseconds is
the slow periodic time value.
The default value is 30000.
Sets a timeout scale for a specific port type. The
default value is 3, and the value ranges from 2 to
10.
January 2012