Important:
Changes made at the global level override and reset all port level settings.
Procedure steps
1. Configure LACP on a port by using the following command:
config {ethernet|pos} <portList> lacp
Specify ethernet for Ethernet ports; pos for Packet over SONET ports.
Variable definitions
Use the data in the following table to help you use the config {ethernet|pos}
<portList> lacp command.
aggregation <true|false>
aggr-wait-time <milliseconds>
disable
enable
fast-periodic-time <milliseconds>
info
key <integer>
mode <active|passive>
partner-key <int>
partner-port <int>
Configuration — Link Aggregation, MLT, and SMLT
Variable
Value
Sets individual port or aggregation for this port.
•
sets the port as aggregation .
true
•
false
sets the port as individual.
The default value is false.
Sets the aggregation wait time (in milliseconds) for
this port.
The default value is 2000.
Disables LACP for this port.
Enables LACP for this port.
The default value is disable.
Sets the fast-periodic time (in milliseconds) for this
port.
The default value is 1000.
Shows the current level parameter settings and next
level directories.
Sets LACP aggregation key for this port. You can
use a default key only for individual ports.
Sets active or passive mode for this port.
The default value is passive.
The LACP partner administrative key. The integer
value ranges from 0 to 65535.
The default value is 0.
Sets the port-partner administrative port value. The
integer value ranges from 0 to 65535.
Configuring LACP on a port
January 2012
89