show mlt error main [<mid>]
show mlt info [<mid>]
show mlt ist info
show mlt lacp info <ifindex>
show mlt show-all [file
<value>]
show mlt stats [<mid>]
show ports info smlt [vlan
<value> ] [port <value>]
show ports info config [vlan
<value> ] [port <value>]
show smlt
Configuring an MLT
Configure an MLT to set up MLTs on the switch.
Procedure steps
1. Configure an MLT by using the following command:
config mlt <mid>
Variable definitions
Use the data in the following table to help you use the config mlt <mid> command.
create
cp-limit {enable|disable}
[multicast-limit
[broadcast-limit
Configuration — Link Aggregation, MLT, and SMLT
Command
Variable
<value>
]
<value>
]
Parameter
Value
Creates a LAG.
Sets the control packet rate limit.
•
enable|disable
enables or disables
control packet rate limit. The default value
is enable. To reenable the ports, issue the
command
config ethernet slot/
Configuring an MLT
January 2012
95