Avaya 8600 Configuration Manual page 68

MLT and SMLT link aggregation configuration using Enterprise Device Manager
12. Select the desired VLANs in the VlanIds dialog box.
13. Click Ok.
14. In the MltType section, select the MLT type.
15. In the Multicast Distribution box, select one of the following:
16. Select or clear the NtStgEnable check box.
17. In the Aggregatable box, select one of the following:
18. In the AggMinLink box, configure the number of active links required for this LAG
19. Click Insert.
Variable definitions
Use the data in the following table to help you configure the MultiLink/LACP Trunks dialog
box.
Variable
Id
PortType
Name
PortMembers
68 Configuration — Link Aggregation, MLT, and SMLT
If you select splitMLT, enter the SMLTID number in the SmltID dialog box that
appears.
• enable
• disable
• enable
• disable
to remain in the forwarding state.
The MLT is added to the MultiLink/LACP Trunks tab in the MLT_LACP box.
Uniquely identifies a value in the MLT.
Sets the value to access or trunk port.
When the aggregatable field is set to enable, this field is read-
only.
The default value is access.
Indicates the name given to the MLT.
The ports assigned to the MLT. 10Base-T, 100Base-TX,
100Base-FX, and Gigabit Ethernet ports support MLT. All ports
in an MLT must have the same settings for speed and duplex,
but can have different media types. All untagged ports must
belong to the same STG.
For Ethernet Routing Switch 8800/8600 modules, up to eight
same-type ports can belong to a single MLT.
When the aggregatable field is set to enable, this field becomes
read-only.
Comments? infodev@avaya.com
Value
January 2012