MLT and SMLT link aggregation configuration using the CLI
show mlt ist info
Configuring a single port SMLT
Configure a split MultiLink trunk that uses a single port. Use single port SMLT to permit the
scaling of the number of SMLT on a switch to the maximum number of available ports.
Important:
You cannot use SMLT on router ports. Only VLACP is supported on single port SMLT.
Prerequisites
• If the port is configured as MLT or MLT-based SMLT, you cannot configure a single port
SMLT.
Procedure steps
1. Configure a single port SMLT by using the following command:
config ethernet <port> smlt <smltid>
Variable definitions
Use the data in the following table to help you use the config ethernet <port> smlt
<smltid> command.
create
delete
info
<port>
<smltid>
106
Configuration — Link Aggregation, MLT, and SMLT
Variable
Comments? infodev@avaya.com
Value
Creates a single port SMLT.
Deletes a single port SMLT.
Shows the port SMLT information.
Specifies the port number
Specifies the MLT ID.
January 2012