Creating A Smlt From An Existing Mlt - Avaya 8600 Configuration Manual

min-links <1-8>
system-priority <integer>

Creating a SMLT from an existing MLT

Create a SMLT from an existing MLT to split physical ports between two switches to improve
resiliency and provide active load sharing.
Prerequisites
• Create an MLT before you create a split in the MLT.
• You must log on to the Global configuration mode in the ACLI.
Procedure steps
1. To log on to the Interface MLT Configuration mode for the MLT that you want to split
2. Create a SMLT from an existing MLT by using the following command:
Variable definitions
Use the data in the following table to help you use the smlt <smltid> command.
Configuration — Link Aggregation, MLT, and SMLT
Variables
enter the following at the ACLI Global configuration command prompt:
interface mlt <mltid>
Tip:
Specify an MLT ID in the range 1-256 for <mltid>.
smlt <smltid>
Creating a SMLT from an existing MLT
Value
Configures the minimum number of active
links (MinLink) required for the LAG to
remain in forwarding state. If the number of
active links falls below this number, the
Avaya Ethernet Routing Switch 8800/8600
declares the entire LAG down.
The default value is 1.
Sets the LACP system priority for a specific
MLT.
• integer is the system priority in the range
0–65535.
The default value is 32768.
January 2012 135