VLACP configuration using the ACLI
show vlacp interface
Variable definitions
The following table defines optional parameters that you enter after the show vlacp
interface command.
fastethernet [vid {vlan-id[-vlan-id][,...]}]
[<portList>]
gigabitethernet [vid {vlan-id[-vlan-id][,...]}]
[<portList>]
Enabling or disabling VLACP globally
Enable or disable the VLACP globally to reset all port level settings on the chassis.
Important:
Changes you make at the global level override and reset all port level settings.
Prerequisites
You must log on to the Global configuration mode in the ACLI.
Procedure steps
1. To globally enable VLACP, use the following command:
2. To globally disable VLACP, use the following command:
148
Configuration — Link Aggregation, MLT, and SMLT
Variable
vlacp enable
Comments? infodev@avaya.com
Value
Displays the VLACP configuration for the
Fastethernet port interface.
•
vlan-id
is the VLAN ID or list of VLAN
IDs to show only ports attached to a
particular VLAN. The range is 1–4094.
•
is the port or port list.
portList
Displays the VLACP configuration for the
GigabitEthernet port interface.
•
is the VLAN ID or list of VLAN
vlan-id
IDs to show only ports attached to a
particular VLAN. The range is 1–4094.
•
is the port or port list.
portList
January 2012