Chapter 10: Mlt And Mlt With Lacp Cli Configuration Examples; Multilink Trunking Configuration Example - Avaya 8600 Configuration Manual

Chapter 10: MLT and MLT with LACP CLI
This section contains configuration examples for configuring MLT and MLT with LACP using the CLI.
For additional configuration examples about MLT with LACP and VLACP, see Link Aggregation Control
Protocol (LACP) 802.3ad and VLACP for ES and ERS Technical Configuration Guide.
For information about SMLT configuration examples, see Switch Clustering Split Multi-Link Trunking
Technical Configuration Guide, NN48500-518 .
You can find the technical configuration guides at
8800/8600 documentation.

MultiLink Trunking configuration example

This configuration example shows how to create a MultiLink Trunk (MLT) and a VLAN between
two Avaya Ethernet Routing Switch 8800/8600 devices. The network depicted in the following
diagram shows a MLT within a VLAN used to carry user traffic.
Figure 13: MLT within a VLAN
The following procedures show how to configure switch S1 and S2 for this example.
Configuring S1:
Configuration — Link Aggregation, MLT, and SMLT
configuration examples
www.avaya.com/support with the rest of the ERS
January 2012 119