Avaya 8600 Configuration Manual page 82

VLACP configuration using Enterprise Device Manager
Procedure steps
1. On the Device Physical View, select a port.
2. In the navigation tree, open the following folders: Configuration > Edit > Port.
3. Double-click General.
4. Click the VLACP tab.
5. In VLACP tab, select the AdminEnable check box to enable VLACP on the port.
6. Configure the remaining fields as required.
7. Click Apply.
Variable definitions
Use the data in the following table to help you configure VLACP on a port.
Variable
AdminEnable
OperEnable
FastPeriodicTimer
SlowPeriodicTimer
Timeout
TimeoutScale
EtherType
EtherMacAddress
82 Configuration — Link Aggregation, MLT, and SMLT
Assigns the enabled status for VLACP for the port.
Indicates the operational status of VLACP for the port.
The default value is false.
Specifies the number of milliseconds between periodic
transmissions using short timeouts. Sets all LACP enabled
ports the same value from this setting. The range is 10–
20000.
The default value is 200.
Specifies the number of milliseconds between periodic
transmissions using long timeouts. Sets all LACP enabled ports
the same value from this setting. The range is 10000–30000.
The default value is 30000.
The timeout control value. Specify long or short timeout.
The default value is long.
Assigns the value used to calculate timeout time from the
periodic time for all VLACP enabled ports. Timeout =
PeriodicTime x TimeoutScale. The range is 2–10.
The default value is 3.
The VLACP protocol identification. The ID is in hexadecimal
format.
The default value is 0x8103.
The multicast MAC address exclusively used for VLACPDUs.
Comments? infodev@avaya.com
Value
January 2012