MLT and MLT with LACP CLI configuration examples
1. Create VLAN 100:
2. Create multilink trunk 10:
Configuring S2:
1. Create VLAN 100:
2. Create multilink trunk 10:
Multilink with LACP configuration example
This configuration example shows how to configure and enable a MultiLink Trunk using
LACP.
You must configure all aggregatable ports to use the same aggregator key used for the MLT.
The following procedures show how to configure switch S1 and S2 in the following diagram as
a MLT with LACP.
Configuring S1:
120
Configuration — Link Aggregation, MLT, and SMLT
ERS-8606:5#config vlan 100 create byport 1
ERS-8606:5#config mlt 10 create
ERS-8606:5#config mlt 10 add ports 1/1,1/2,2/1,2/2
ERS-8606:5# config mlt 10 add vlan 100
ERS-8606:5#config vlan 100 create byport 1
ERS-8606:5#config mlt 10 create
ERS-8606:5#config mlt 10 add ports 1/1,1/2,2/1,2/2
ERS-8606:5#config mlt 10 add vlan 100
Comments? infodev@avaya.com
January 2012