Nikon Eclipse TI-TIRF-E Setup Manual page 71

TI-LUSU shutter unit
Safety cover signal connector
Laser unit connector
Serial IF connector
RS-232C
LASER SHUTTER
Laser shutter
switch / indicator
Exclusive use for TI-TIRF system
Don't use this unit with other systems.
TI-LU4SU shutter unit LU4
Laser unit connector
Option switch
TI-LU4SU
Laser shutter
switch
Optical path selector knob (on the microscope body)
Chapter 1 System Configurations and Part Names
1.4 Name of Each Part
Eyepiece optical path
signal connector
AC adapter
connector
Safety cover
close lamp
INPUT
LASER UNIT
12V
SAFETY
1A
COVER
CLOSE
BINO
CLOSE
POWER
TI-LUSU
Figure 1.4-39
Indicator lamp
LASER
EMISSION
POWER
Figure 1.4-40
PORT dial
(optical path selector knob)
Figure 1.4-41
The shutter unit controls motorized shutters in the
laser unit.
Use this unit in combination with the C-LU2, C-LU3 or
C-LU3EX laser unit.
Eyepiece optical
path closed lamp
Power switch
Power lamp
The shutter unit controls motorized shutters in the
laser unit.
Use this unit in combination with the LU4A laser
unit.
If the safety interlock functions, all the shutters are
closed, and the lamp turns off.
To unlock the safety interlock, solve what caused
the safety interlock being locked, then cancel the
Power lamp
safety interlock from the software.
The laser shutter does not open when the binocular
route of the optical path ("EYE") is selected.
Ti-U *
EYE Visual observation 100%
R Right port 100%
AUX Auxiliary port
(Visual observation/left port
= 20:80)
(Visual observation/right port
= 20:80)
L Left port 100%
* The Ti-U is also available with an optical-path
splitter prism preinstalled at the auxiliary port. The
light intensity ratio of visual observation to left port
is 20 to 80.
In this case, set the optical path selector knob as
follows:
EYE Observation port 100%
R Right port 100%
L80 Visual observation/left port = 20:80
L Left port 100%
1-57
Ti-U/B
EYE Visual observation 100%
R Right port 100%
B Bottom port 100%
L Left port 100%