Nikon Eclipse TI-TIRF-E Setup Manual page 237

Chapter 6 Connection between the Laser Unit and the Microscope
6.2 Attaching the Optical Fiber to the Light Source
Using C1 single mode fiber
Draw the optical fiber through the round ring metal cover and attach the optical fiber to the FC connector.
When inserting the cable, be sure to align it with the FC connector's notch, and then fully screw in the
knurled section. After attaching the fiber, tighten the clamp screw to secure the round ring metal cover.
Round ring metal cover
Fiber
FC connector
Figure 6.2-2
(The figure shows TI-TIRF.)
1-223