Table of Contents
Advertisement
4
561-nm solid-state laser installation
Normally, the green HeNe laser adapters are attached to the four-laser module A at the product is
shipped from the factory. To use the 561-nm solid-state laser, loosen four hexagonal bolts of the green
HeNe laser adapters and remove the green HeNe laser adapters along with the hexagonal bolts.
561-nm laser
561-nm laser adapter
Figure 5.4-24
Figure 5.4-25
Figure 5.4-26
This is the end of the laser installation.
Chapter 5 Laser Unit
5.4 LU4A Four-laser Module A
Black ring
Laser adapter cover
1.
Attach the 561-nm laser adapter (provided with the
four-laser module A) onto the 561-nm laser. And
then, attach a black ring to the laser emission port.
2.
Mount the 561-nm laser body onto the L4 position.
Fix the laser body with four bolts provided with the
four-laser module A.
3.
Detach the screw near the emission port of the
561-nm laser adapter temporarily.
4.
Attach the 561-nm laser adapter cover provided with
the laser unit and fix it with the screw detached in
step 3.
1-165
Hide quick links:
Advertisement
Table of Contents
