Table of Contents
Advertisement
Meaning of the Symbols Used on the Product
The symbols marked on the product indicate the need for caution at all times during use.
Always refer to the instruction manual and read the relevant instructions before manipulating any part
to which the symbol is marked.
Symbol Meaning
Warning label - laser hazard symbol
This symbol is displayed on the laser safety cover or on the stage to warn that the product
emits laser light.
Your eyes or skin may be exposed to the laser light emitted from the objective, resulting in
injury.
Precautions against heat
This symbol, affixed to the top of the dia pillar illuminator, the rear side of the 12V-100W
lamp house, the HG fiber light source, and the rear side of the super-high pressure
mercury lamp (or the xenon lamp) house, calls your attention.
• The lamp and the lamphouse become hot while the lamp is lit and immediately after it
is turned off.
• Do not touch the lamp and the lamphouse while the lamp is on and immediately after it
is turned off to prevent the risk of burns.
• Make sure that the lamp and the lamphouse are sufficiently cool before the lamp
replacement.
Biohazard
This symbol on the upper part of the microscope calls your attention on the following:
• If a specimen is spilled onto the product, it may cause the danger of biohazard.
• To avoid biohazard contamination, do not touch the contaminated portion with your
bare hands.
• Decontaminate the contaminated portion according to the standard procedure of your
facility.
General attention
This symbol is displayed on the top of the protection plate (for nosepiece) appended to the
Ti-E and Ti-E/B and the protection plate (for PFS6 nosepiece) appended to the TI-ND6-PFS
motorized PFS6 nosepiece. It calls your attention on the following:
• To avoid accidents such as finger pinching and exposure to laser radiation, install this
product in the correct position.
Safety Precautions
3
Hide quick links:
Advertisement
Table of Contents
