Nikon Eclipse TI-TIRF-E Setup Manual page 226

Mounting HeNe laser (25LGP series)
1. Turn on the key switch of the HeNe laser power supply.
2. Secure the HeNe laser power supply in the position [3] with the provided clamp [2].
3. Connect the power cable [4] (HeNe-543nm) to the HeNe laser power supply.
4. Connect the cable (to be connected to the HeNe laser head) to the HeNe laser power
supply through the cable port on the rear side.
Clamp
HeNe laser
power supply
CAUTION
• Mount the HeNe laser power supplies that meet the local power requirements. Misuse of the
power supplies result in damage.
Chapter 5 Laser Unit
5.5 Setting Up the LU-LR Four-laser PS Rack
Figure 5.5-25
Figure 5.5-26
1-212
Power cable
(HeNe-543nm)
To the HeNe
laser head
Key switch