Managing Configuration Files - D-Link DWS-1008 User Manual

DWS-1008 User's Manual
DWS-1008# mkdir corp2
success: change accepted.
DWS-1008# dir
=============================================================
file:
Filename
file:configuration
file:configuration.txt
corp2/
corp_a/
file:dangcfg
dangdir/
old/
Total:
=============================================================
Boot:
Filename
*boot0:bload
*boot0:DWS030000.008
boot1:DWS030000.008
Boot0: Total:
Boot1: Total:
=============================================================
temporary files:
Filename
Total:
Removing a Subdirectory
To remove a subdirectory from nonvolatile storage, use the following command:
rmdir [subdirname]
To remove subdirectory corp2, type the following example:
DWS-1008# rmdir corp2
success: change accepted.
Managing Configuration Files
A configuration file contains CLI commands that set up the switch. The switch loads a
designated configuration file immediately after loading the system software when the software
is rebooted. You also can load a configuration file while the switch is running to change the
switch's configuration.
When you enter CLI commands to make configuration changes, these changes are immediately
added to the device's running configuration but are not saved to the configuration file.
D-Link Systems, Inc.
Size
17 KB
379 bytes
512 bytes
512 bytes
13 KB
512 bytes
512 bytes
33 Kbytes used, 207822 Kbytes free
Size
746 KB
8182 KB
8197 KB
8928 Kbytes used, 3312 Kbytes free
8197 Kbytes used, 4060 Kbytes free
0 bytes used, 93537 Kbytes free
Created
May 21 2004, 18:20:53
May 09 2004, 18:55:17
May 21 2004, 19:22:09
May 21 2004, 19:15:48
May 16 2004, 18:30:44
May 16 2004, 17:23:44
Sep 23 2003, 21:58:48
Created
May 09 2004, 19:02:16
May 09 2004, 18:58:16
May 21 2004, 18:01:02
Size Created
Managing System Files
372