D-Link DWS-1008 User Manual page 227

DWS-1008 User's Manual
bridge forward delay
topology change initiator
last topology change occurred: Tue Jul 01 2003 22:33:36.
topology change
topology change time
topology change detected
topology change count
topology change last recvd. from 00-0b-0e-02-76-f6
Other port specific info
dynamic max age transition
port BPDU ok count
msg age expiry count
link loading
BPDU in processing
num of similar BPDU's to process
received_inferior_bpdu
next state
src MAC count
total src MAC count
curr_src_mac
next_src_mac
Clearing STP Statistics
To clear the STP statistics counters, use the following command:
clear spantree statistics port-list [vlan vlan-id]
As soon as you enter the command, MSS resets the STP counters for the specified ports or
VLANs to 0. The software then begins incrementing the counters again.
Spanning Tree Configuration Scenario
This scenario configures a VLAN named backbone for a switch's connections to the
network backbone, adds ports 2 and 3 to the VLAN, and enables STP on the VLAN to
prevent loops.
1. Remove the network cables from ports 2 and 3 or use MSS to disable the ports. This
prevents a loop until you complete the STP configuration. To disable the ports and verify the
results, type the following commands:
DWS-1008# set port disable 2-3
success: set "disable" on port 2-3
D-Link Systems, Inc. D-Link Systems, Inc.
15
0
FALSE
35
FALSE
1
0
21825
0
0
FALSE
0
FALSE
0
21807
21825
00-0b-0e-00-04-30
00-0b-0e-02-76-f6
Configuring and Managing STP
222 222