D-Link DWS-1008 User Manual page 139

DWS-1008 User's Manual
AP Parameters
The table below summarizes parameters that apply to individual access points, including
dual-homing parameters.
Parameter
name
bias
group
upgrade
firmware
blink
D-Link Systems, Inc.
Default Value Description
Based on AP name.
the port or
Distributed AP
connection
number. For
example:
• DWL-8220AP
high
Setting a DWL-8220AP's bias
on an switch to high causes
the switch to be preferred
over switches with low bias,
for booting and managing the
AP.
Note: Bias applies only to
switches that are indirectly
attached to the AP through an
intermediate Layer 2 or Layer
3 network. an AP
always attempts to boot
on AP port 1 first, and if an
switch is directly attached
on AP port 1, the AP boots
from it regardless of the bias
settings.
None Named set of AP access
points. MSS load-balances
user sessions among the
access points in the group.
enable Automatic upgrade of boot
firmware.
disable
LED blink mode - blinking
LEDs on a DWL-8220AP
make the AP visually easy to
identify.
Configuring DWL-8220AP Access Points
134