D-Link DWS-1008 User Manual page 155

DWS-1008 User's Manual
APs that receive their configurations from the template also receive the radio settings from
the radio profile used by the template. Likewise, the SSIDs and encryption settings come
from the service profiles mapped to the radio profile. To use a radio profile other than default,
you must specify the radio profile you want to use.
Changing AP Parameter Values
The commands for configuring AP and radio parameters for the template are the same as the
commands for configuring an individual Distributed AP. Instead of specifying a Distributed AP
number with the command, specify auto.
AP Parameters:
set dap auto mode {enable | disable}
set dap auto bias {high | low}
set dap auto upgrade-firmware {enable | disable}
set dap auto group name
set dap auto blink {enable | disable}
Radio Parameters:
set dap auto radiotype {11a | 11b| 11g}
set dap auto radio {1 | 2} mode {enable | disable}
set dap auto radio {1 | 2} radio-profile name mode {enable | disable}
set dap auto radio {1 | 2} auto-tune max-power power-level
set dap auto radio {1 | 2} auto-tune max-retransmissions retransmissions
set dap auto radio {1 | 2} auto-tune min-client-rate rate
Enabling the Template
To enable the template for automatic Distributed AP configuration, type the following
command:
DWS-1008# set dap auto mode enable
success: change accepted.
Specifying the Radio Profile Used by the Template
The template uses radio profile default by default. To use another radio profile instead, use
the following command:
set dap auto radio {1 | 2} radio-profile name mode {enable | disable}
The following command changes the template to use radio profile autodap1 for radio 1:
DWS-1008# set dap auto radio 1 radio-profile autodap1
success: change accepted.
Note: You must configure the radio profile before you can apply it to the template.
D-Link Systems, Inc.
Configuring DWL-8220AP Access Points
150