D-Link DWS-1008 User Manual page 174

DWS-1008 User's Manual
Disabling or Reenabling All Radios Using a Profile
To disable or reenable all radios that are using a radio profile, use the following command:
set radio-profile name [mode {enable | disable}]
The following command enables all radios that use radio profile rp1:
DWS-1008# set radio-profile rp1 mode enable
success: change accepted.
The following commands disable all radios that use radio profile rp1, change the beacon
interval, then reenable the radios:
DWS-1008# set radio-profile rp1 mode disable
success: change accepted.
DWS-1008# set radio-profile rp1 beacon-interval 200
success: change accepted.
DWS-1008# set radio-profile rp1 mode enable
success: change accepted.
Resetting a Radio to its Factory Default Settings
To disable an AP radio and reset it to its factory default settings, use the following
command:
clear {ap port-list | dap dap-num} radio {1 | 2 | all}
This command performs the following actions:
• Sets the transmit power, channel, and external antenna type to their default values.
• Removes the radio from its radio profile and places the radio in the default radio
profile.
This command does not affect the PoE setting.
To disable and reset radio 2 on the access point connected to port 3, type the following
command:
D-Link Systems, Inc.
Configuring DWL-8220AP Access Points
169