D-Link DWS-1008 User Manual page 198

DWS-1008 User's Manual
8. Apply radio profile rp2 to radio 1 on port 5 and to radios 1 and 2 on port 6, enable the
radios, and verify the configuration changes. Type the following commands:
DWS-1008# set ap 5,6 radio 1 radio-profile rp2 mode enable
success: change accepted.
DWS-1008# set ap 6 radio 2 radio-profile rp2 mode enable
success: change accepted.
DWS-1008# show ap config
Port 5: AP model: DWL-8220AP, POE: enable, bias: high, name: AP05
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp2
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Port 6: AP model: DWL-8220AP, POE: enable, bias: high, name: AP6
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: enabled, channel: 6
tx pwr: 1, profile: rp2
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp2
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
9. Save the configuration. Type the following command:
DWS-1008# save config
success: configuration saved.
Configuring Encryption for MAC Clients
The following example shows how to configure MSS to provide PSK authentication and
TKIP or 40-bit WEP encryption for MAC clients:
1. Create an authentication rule that sends all MAC users of SSID voice to the local database
for authentication and authorization. Type the following command:
DWS-1008# set authentication mac ssid voice * local
success: configuration saved.
2. Configure a MAC user group named wpa-for-mac that assigns all MAC users in the group
to VLAN blue. Type the following command:
DWS-1008# set mac-usergroup wpa-for-mac attr vlan-name blue
success: configuration saved.
D-Link Systems, Inc. D-Link Systems, Inc.
Configuring User Encryption
193 193