D-Link DWS-1008 User Manual page 39

DWS-1008 User's Manual
The following example sets ports 1, 2, and 4 for the DWL-8220AP access point:
DWS-1008# set port type ap 1,2,4 model dwl-8220ap poe enable
This may affect the power applied on the configured ports.
Would you like to continue? (y/n) [n]y
success: change accepted.
To verify the configuration change, use the following command:
show ap config [port-list [radio {1 | 2}]]
Here is an example:
DWS-1008# show ap config 1
Port 1: AP model: dwl-8220ap, POE: enable, bias: high, name: AP01
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 15, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
Configuring for a Distributed AP
To create a configuration for a Distributed AP (referred to as a DAP in the CLI), use the
following command:
set dap dap-num serial-id serial-ID
model {DWL8220AP}
[radiotype {11a | 11b| 11g}]
The dap-num parameter identifies the Distributed AP connection for the AP. The range of
valid connection ID numbers is from 1 to 30.
For the serial-id parameter, specify the serial ID of the AP. The serial ID is listed on the AP
case. To display the serial ID using the CLI, use the show version details command. The
model and radiotype parameters have the same options as they do with the set port type ap
command. Because the switch does not supply power to an indirectly connected AP, the set
dap command does not use the poe parameter.
D-Link Systems, Inc.
Configuration (continued)
Configuration
34