D-Link DWS-1008 User Manual page 378

DWS-1008 User's Manual
This section describes how to display the running configuration and the configuration file, and
how to save and load configuration changes. A procedure is also provided for resetting the
switch to its factory default configuration.
Displaying the Running Configuration
To display the configuration running on the switch, use the following command:
show config [area area] [all]
The area area parameter limits the display to a specific configuration area.
The all parameter includes all commands that are set at their default values. Without the all
parameter, the show config command lists only those configuration commands that set a
parameter to a value other than the default.
To display the running configuration, type the following command:
DWS-1008# show config
# Configuration nvgen'd at 2004-5-10 19:08:38
# Image 2.1.0
# Model DWS-1008
# Last change occurred at 2004-5-10 16:31:14
set trace authentication level 10
set ip dns server 10.10.10.69 PRIMARY
set ip dns server 10.20.10.69 SECONDARY
set ip route default 10.8.1.1 1
set log console disable severity debug
set log session disable severity alert
set log buffer enable severity error messages 200
set log trace disable severity error mbytes 10
set log server 192.168.253.11 severity critical
set timezone PST -8 0
set summertime PDT start first sun apr 2 0 end last sun oct 2 0
set system name DWS-1008
set system countrycode US
set system contact trapeze-pubs
set radius server r1 address 192.168.253.1 key sunflower
set server group sg1 members r1
set enablepass password b6b706525e1814394621eeb2a1c4d5803fcf
set authentication console * none
set authentication admin * none
set user tech password encrypted 1315021018
press any key to continue, q to quit.
D-Link Systems, Inc.
Managing System Files
373