D-Link DWS-1008 User Manual page 45

DWS-1008 User's Manual
The following command configures radio profile rp1:
DWS-1008# set radio-profile rp1
success: change accepted.
The table below lists the radio profile parameters and their default values.
Parameter
11g-only
active-scan
beacon-interval
countermeasures
dtim-interval
frag-threshold
long-retry
max-rx-lifetime
max-tx-lifetime
preamble-length
rts-threshold
D-Link Systems, Inc.
Configuration (continued)
Default Value
disable
enable
100
Not configured
1
2346
5
2000
2000
short
2346
Radio Behavior When Parameter Set To Default Values
Allows associations with802.11g and 802.11b
clients. This parameter applies only to 802.11b/g
radios.
Sends probe any requests (probe requests with a
null SSID name) to solicit probe responses from
other access points.
Waits 100 ms between beacons.
Does not issue countermeasures against any
device.
Sends the delivery traffic indication map (DTIM)
after every beacon.
Transmits frames up to 2346 bytes long without
fragmentation.
Sends a long unicast frame up to five times
without acknowledgment.
Allows a received frame to stay in the buffer for up
to 2000 ms (2 seconds).
Allows a frame that is scheduled for transmission
to stay in the buffer for up to 2000 ms (2 seconds).
Advertises support for short 802.11b preambles,
accepts either short or long 802.11b preambles,
and generates unicast frames with the preamble
length specified by the client.
Transmits frames longer than 2346 bytes by means
of the Request-to-Send/Clear-to-Send (RTS/CTS)
method.
Configuration
40