D-Link DWS-1008 User Manual page 200

DWS-1008 User's Manual
8. Enable the WEP40 cipher suite in service profile wpa-wep-for-mac. Type the following
command:
DWS-1008# set service-profile wpa-wep-for-mac cipher-wep40 enable
success: change accepted.
TKIP is already enabled by default when WPA is enabled.
9. Enable PSK authentication in service profile wpa-wep-for-mac. Type the following
command:
DWS-1008# set service-profile wpa-wep-for-mac auth-psk enable
success: change accepted.
10. Configure a passphrase for the preshared key. Type the following command:
DWS-1008# set service-profile wpa-wep-for-mac psk-phrase "passphrase to convert
into a preshared key"
success: change accepted.
11. Display the WPA configuration changes. Type the following command:
DWS-1008# show service-profile wpa-wep-for-mac
ssid-name:
beacon:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Long Preamble:
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: pre-shared key
TKIP countermeasures time: 60000ms
pre-shared-key: 92f99cd49e186cadee13fda7b2a2bac78975 a5723a4a6b31b5b5395d6
b001dbe
12. Map service profile wpa-wep-for-mac to radio profile rp3. Type the following commands:
DWS-1008# set radio-profile rp3 service-profile wpa-wep-for-mac
success: change accepted.
13. Apply radio profile rp3 to radio 1 on port 4 and to radios 1 and 2 on port 6 and enable
the radios, and verify the configuration changes. Type the following commands:
DWS-1008# set ap 4,6 radio 1 radio-profile rp3 mode enable
success: change accepted.
DWS-1008# set ap 6 radio 2 radio-profile rp3 mode enable
success: change accepted.
D-Link Systems, Inc. D-Link Systems, Inc.
voice ssid-type:
yes auth-fallthru: none
<none> WEP Key 2 value:
<none> WEP Key 4 value:
1 WEP Multicast Index:
YES Shared Key Auth:
crypto
<none>
<none>
1
NO
Configuring User Encryption
195 195