D-Link DWS-1008 User Manual page 209

DWS-1008 User's Manual
Changing the Maximum Default Power Allowed On a Radio
By default, the maximum default power level that RF AutoTuning can set on a radio is the same
as the maximum power level allowed for the country of operation. To change the maximum
default power level that RF AutoTuning can assign, use the following command:
set {ap port-list | dap dap-num} radio {1 | 2} auto-tune max-power power-level
The power-level can be a value from 1 to 20.
To set the maximum power that RF AutoTuning can set on radio 1 on the DWL-8220AP
access point on port 7 to 12 dBm, type the following command:
DWS-1008# set ap 7 radio 1 auto-tune max-power 12
success: change accepted.
Changing the Client Retransmission Threshold
By default, the maximum percentage of client retransmissions a radio can experience before
RF AutoTuning considers changing the channel on the radio is 10 percent. You can change
the threshold to value from 1 to 100 percent. To change the max-retransmissions threshold,
use the following command:
set {ap port-list | dap dap-num} radio {1 | 2} auto-tune max-retransmissions
retransmissions
Examples: To change the max-retransmissions threshold to 20 percent for radio 1 on the
directly connected AP access port on port 7, type the following command:
DWS-1008# set ap 7 radio 1 auto-tune max-retransmissions 20
success: change accepted.
Changing the Minimum Transmit Data Rate
By default, a radio does not lower the transmit data rate for any client below the following
values:
• 5.5 Mbps for 802.11b/g clients
• 24 Mbps for 802.11a clients
To change the minimum transmit data rate for 802.11b/g clients or 802.11a clients, use the
following command:
set {ap port-list | dap dap-num} radio {1 | 2} auto-tune min-client-rate rate
The rate can be one of the following:
• For 802.11g radios - 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, or 1
• For 802.11b radios - 11, 5.5, 2, or 1
• For 802.11a radios - 54, 48, 36, 24, 18, 12, 9, or 6
D-Link Systems, Inc.
Configuring RF Auto-Tuning
204