D-Link DWS-1008 User Manual page 379

DWS-1008 User's Manual
To display only the VLAN configuration commands, type the following command:
DWS-1008# show config area vlan
# Configuration nvgen'd at 2004-5-10 19:08:38
# Image 2.1.0
# Model DWS-1008
# Last change occurred at 2004-5-10 16:31:14
set vlan 1 port 1
set vlan 10 name backbone tunnel-affinity 5
set vlan 10 port 21
set vlan 10 port 22
set vlan 3 name red tunnel-affinity 5
set igmp mrsol mrsi 60 vlan 1
set igmp mrsol mrsi 60 vlan 10
Saving Configuration Changes
To save the running configuration to a configuration file, use the following command:
save config [filename]
If you do not specify a filename of up to 128 alphanumeric characters, the command replaces
the startup configuration file that was loaded the last time the software was rebooted.
To save the running configuration to the file loaded the last time the software was rebooted,
type the following command:
DWS-1008# save config
success: configuration saved.
To save the running configuration to a file named newconfig, type the following command:
DWS-1008# save config newconfig
success: configuration saved to newconfig.
Specifying the Configuration File to Use After the Next Reboot
By default, the switch loads the configuration file named configuration from nonvolatile storage
following a software reboot. To use a different configuration file in nonvolatile storage after
rebooting, use the following command:
set boot configuration-file filename
To configure a DWS-1008 switch to load the configuration file floor2 from nonvolatile storage
following the next software reboot, type the following command:
DWS-1008# set boot configuration-file floor2
success: boot config set.
D-Link Systems, Inc.
Managing System Files
374