D-Link DWS-1008 User Manual page 186

DWS-1008 User's Manual
The table below lists the encryption support for WPA and non-WPA clients.
Encryption Support for WPA and Non-WPA Clients
MSS
Encryption
Type
WPA—CCMP
WPA—TKIP
WPA—WEP40
WPA—WEP104
Dynamic WEP
Static WEP
Configuring WPA
To configure DWL-8200AP access point radios to support WPA:
1. Create a service profile for each SSID that will support WPA clients.
2. Enable the WPA IE in the service profile.
3. Enable the cipher suites you want to support in the service profile. (TKIP is enabled
by default.) Optionally, you also can change the countermeasures timer value for
TKIP.
4. Map the service profile to the radio profile that will control IEEE settings for the
radios.
5. Assign the radio profile to the radios and enable the radios.
If you plan to use PSK authentication, you also need to enable this authentication method
and enter an ASCII passphrase or a hexadecimal (raw) key.
Creating a Service Profile for WPA
Encryption parameters apply to all users who use the SSID configured by a service profile.
To create a service profile, use the following command:
set service-profile name
D-Link Systems, Inc. D-Link Systems, Inc.
Client Encryption Type
WPA—
WPA—TKIP
CCMP
Supported
Supported
WPA— WPA—
WEP40 WEP104
Supported
Supported
Configuring User Encryption
Dynamic
Static WEP
WEP
Supported
Supported
Supported
Supported
181 181